As you all know, I am a Sea Cadet, and keeping uniform up to it’s best standards is one of the major responsibilities, especially when you are a senior like me. The boots I have are from the late 1950s; this means that there is organic leather which makes the boot easier to shine than it’s new counterparts. This leather allowed me to polish the boots up super fast and make them ready for cadet nights in 1 to 2 and a half hours. However, I was faced with a constant problem; the polish would flake, creating uneven surfaces on the boot, also known as boot cancer. To fix this, there are two routes; you may either strip the boot (take off the layers) which will take you a long time to rebuild the layers, or polish over and smooth out the surfaces. From my 6+ years of experience in Cadets, it is best to strip the boots and to build them up from the ground again. This however, didn’t help the issue, and the polish kept on flaking and falling off. I decided to try the other method out as well, where I build polish on top of the cancerous areas. This too didn’t work, in fact it only worsened as the dried out polish didn’t stick well to the more humid polish.
This brought me back to the drawing board, as I wasn’t sure of what to do at this point. I was ver desperate at this point, even thinking about leaving my question on Reddit when I remembered about something; My Friends! Being very desperate I shot them all a message, hoping for the best. They went with me to the Summer’s Military camp, making them a reliable source especially since I knew all of them personally. I have showed them pictures of my boots and asked about their opinion, and sure enough they pointed out one detail that I failed to notice. The boot was dry! They joked around saying “how about you offer it a drink or two” and even “ain’t you a sea man?”, “ain’t they supposed to be hydrated 24/7?”.
They were right; I was too concentrated to look good which caused me to not pay attention to the minor details. Using their help as a guide I stripped the boots (it took ~20 minutes for each boot) and applied the one thing the boot needed; The Moisturizer. After that, I buffed (term for building up layers of polish, in this case I have built up the first the 3 layers with a buffing brush) the boots and left them out to dry. This will create a so called steady base layer on which the whole polish relies on. This process is currently in the making and I can’t wait to share any future results/personal experience with what happens next.